Click image to view full size image
passive tag rfid reader smart card reader access control systems
Specification
*Less than 0.2 second Response Speed
*Less than 0.5 seconds Proximity Time Distance:
*5-10cm Proximity Range
*Support UEM 4100 ID Card or compatible with it( 64bits, Manchester Code) and Mifare 1 Card (13.56 MHz Frequency)
*-25C to 75C Ambient Temperature, 10%-90% Ambient Humidity
*Built-in Antenna
*Built-in LED (Double Color LED)
*Built-in Loud Speaker (Buzzer)
*DC 12V Working Voltage, 70mA Working Current
*100 Meters Communication Distance
*Real Time Data Transfer
*Black Color
*PVC Case Material (Black Resin for Water-Proof Function)
*120mm*76mm*25mm
Installation
Using + screw driver to loosen the screw between the panel and motherboard. And then embed the motherboard to the side wall with the plastic plug and screws.
Wire Connection
Red DC 5V-16V
Black GND
Blue D1
White D0
Brown BEEP
Green LED
Yellow Alarm
Notice
1. Confirm the electric voltage (DC12V) and differentiate positive anode and cathode of power supply
2. When external Power is used, make sure sharing the power with Controller Box or using the same GND
3. When the distance between card reader and controller is more than 50m, please use Power Line with at least 1.5 square cm Dia, or using several parallel Network wires
Specification
*Less than 0.2 second Response Speed
*Less than 0.5 seconds Proximity Time Distance:
*5-10cm Proximity Range
*Support UEM 4100 ID Card or compatible with it( 64bits, Manchester Code) and Mifare 1 Card (13.56 MHz Frequency)
*-25C to 75C Ambient Temperature, 10%-90% Ambient Humidity
*Built-in Antenna
*Built-in LED (Double Color LED)
*Built-in Loud Speaker (Buzzer)
*DC 12V Working Voltage, 70mA Working Current
*100 Meters Communication Distance
*Real Time Data Transfer
*Black Color
*PVC Case Material (Black Resin for Water-Proof Function)
*120mm*76mm*25mm
Installation
Using + screw driver to loosen the screw between the panel and motherboard. And then embed the motherboard to the side wall with the plastic plug and screws.
Wire Connection
Red DC 5V-16V
Black GND
Blue D1
White D0
Brown BEEP
Green LED
Yellow Alarm
Notice
1. Confirm the electric voltage (DC12V) and differentiate positive anode and cathode of power supply
2. When external Power is used, make sure sharing the power with Controller Box or using the same GND
3. When the distance between card reader and controller is more than 50m, please use Power Line with at least 1.5 square cm Dia, or using several parallel Network wires